# Programming support using avrdude. Settings and variables.

# Programming hardware: alf avr910 avrisp bascom bsd
# dt006 pavr picoweb pony-stk200 sp12 stk200 stk500
#
# Type: avrdude -c ?
# to get a full listing.
#

BURN=avrdude
BURNPORT=com2

ifeq ($(MCU),atmega128)
BURNTARGET=m128
endif
ifeq ($(MCU),atmega2561)
BURNTARGET=m2561
endif
ifeq ($(BURNTARGET),)
BURNTARGET=$(MCU)
endif

#BURNFLAGS=-dprog=stk500 -dserial=$(BURNPORT) -dspeed=115200 -dpart=$(BURNTARGET) --erase --upload if=$(TARG)

AVRDUDE_PROGRAMMER = stk500v2

AVRDUDE_WRITE_FLASH = -U flash:w:$(TARG)
#AVRDUDE_WRITE_EEPROM = -U eeprom:w:$(TARGET).eep

AVRDUDE_FLAGS = -p $(BURNTARGET) -P $(BURNPORT) -c $(AVRDUDE_PROGRAMMER)

# Uncomment the following if you want avrdude's erase cycle counter.
# Note that this counter needs to be initialized first using -Yn,
# see avrdude manual.
#AVRDUDE_ERASE += -y

# Uncomment the following if you do /not/ wish a verification to be
# performed after programming the device.
AVRDUDE_FLAGS += -V

# Increase verbosity level.  Please use this when submitting bug
# reports about avrdude. See <http://savannah.nongnu.org/projects/avrdude>
# to submit bug reports.
#AVRDUDE_FLAGS += -v -v

BURNFLAGS = $(AVRDUDE_FLAGS) $(AVRDUDE_WRITE_FLASH) $(AVRDUDE_WRITE_EEPROM)