#
# For more information about the configuration files, take a 
# look at the "Open On-Chip Debugger (openocd)" documentation.
#
# This config file was tested with OpenOCD version r717
#

# daemon configuration
telnet_port 4444
gdb_port 3333

# tell gdb our flash memory map
# and enable flash programming
gdb_memory_map enable
gdb_flash_program enable

#
# interface, if you want to use an other interface
# you must replace this section here
#
#################### interface start ####################

interface ft2232
ft2232_device_desc "Turtelizer JTAG/RS232 Adapter"
ft2232_layout turtelizer2
ft2232_vid_pid 0x0403 0xbdc8

##################### interface end #####################

# jtag speed
# start slow, speed up after reset
jtag_khz 1000 6000

#delays on reset lines
jtag_nsrst_delay 200
jtag_ntrst_delay 200

#use combined on interfaces or targets that can't set TRST/SRST separately
reset_config srst_only srst_pulls_trst

#jtag scan chain
#format L IRC IRCM IDCODE (Length, IR Capture, IR Capture Mask, IDCODE)
jtag_device 4 0x1 0xf 0xe

#target <type> <startup mode>
#target arm7tdmi <reset mode> <chainpos> <endianness> <variant>
target arm7tdmi little run_and_init 0 arm7tdmi
run_and_halt_time 0 30

target_script 0 reset eir1ocd.ini

working_area 0 0x00200000 0x4000 nobackup

#flash bank <driver> <base> <size> <chip_width> <bus_width>
flash bank at91sam7 0 0 0 0 0

#################### command section ####################

# must start with init
init
reset init