2.3-InternetRadio/nutos/nut/include/cfg/modem.h

#ifndef _CFG_MODEM_H_
#define _CFG_MODEM_H_

/*
 * Copyright (C) 2001-2004 by egnite Software GmbH. All rights reserved.
 *
 * Redistribution and use in source and binary forms, with or without
 * modification, are permitted provided that the following conditions
 * are met:
 *
 * 1. Redistributions of source code must retain the above copyright
 *    notice, this list of conditions and the following disclaimer.
 * 2. Redistributions in binary form must reproduce the above copyright
 *    notice, this list of conditions and the following disclaimer in the
 *    documentation and/or other materials provided with the distribution.
 * 3. Neither the name of the copyright holders nor the names of
 *    contributors may be used to endorse or promote products derived
 *    from this software without specific prior written permission.
 *
 * THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS
 * ``AS IS'' AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT
 * LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS
 * FOR A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE
 * COPYRIGHT OWNER OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT,
 * INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING,
 * BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS
 * OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED
 * AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY,
 * OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF
 * THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF
 * SUCH DAMAGE.
 *
 * For additional information see http://www.ethernut.de/
 *
 */

/*
 * $Log$
 * Revision 1.5  2005/04/19 09:02:17  haraldkipp
 * Ole's mishap repaired
 *
 * Revision 1.5  2005/01/22 19:26:34  haraldkipp
 * Marked deprecated.
 *
 * Revision 1.4  2004/03/08 11:17:58  haraldkipp
 * Hardware handshake disabled by default.
 *
 * Revision 1.3  2003/12/15 19:27:11  haraldkipp
 * Ethernut 2 handshake lines
 *
 * Revision 1.2  2003/08/05 20:17:46  haraldkipp
 * Typing errors corrected
 *
 * Revision 1.1.1.1  2003/05/09 14:41:04  haraldkipp
 * Initial using 3.2.1
 *
 * Revision 1.1  2003/05/06 18:37:33  harald
 * *** empty log message ***
 *
 */

/*!
 * \file cfg/modem.h
 * \brief RS232 handshake hardware specification.
 *
 * Including this file is deprecated. Use cfg/arch/avr.h.
 */

/*!
 * \addtogroup xgModemCfg
 */
/*@{*/

#warning Using this file is deprecated, just include <cfg/arch/avr.h> instead

#if 0

/*! Port output register of \ref UART0_RTS_BIT. */
#define UART0_RTS_PORT  PORTE
/*! Data direction register of \ref UART0_RTS_BIT. */
#define UART0_RTS_DDR   DDRE
/*! \brief RTS handshake control bit.
 *
 * If undefined, RTS handshake is not supported.
 */
#define UART0_RTS_BIT   2


/*! Port output register of \ref UART0_CTS_BIT. */
#define UART0_CTS_PORT   PORTE
/*! Port input register of \ref UART0_CTS_BIT. */
#define UART0_CTS_PIN    PINE
/*! Data direction register of \ref UART0_CTS_BIT. */
#define UART0_CTS_DDR    DDRE
/*! Interrupt signal of \ref UART0_CTS_BIT. */
#define UART0_CTS_SIGNAL sig_INTERRUPT7
/*! \brief CTS handshake sense bit.
 *
 * If undefined, CTS handshake is not supported.
 */
#define UART0_CTS_BIT    7


/*! Port output register of \ref UART0_HDX_BIT. */
#define UART0_HDX_PORT  PORTD
/*! Data direction register of \ref UART0_HDX_BIT. */
#define UART0_HDX_DDR   DDRD
/*! \brief Half duplex control bit.
 *
 * If undefined, half duplex is not supported.
 */
#define UART0_HDX_BIT   4

#endif


#if 0

/*! Port output register of \ref UART1_RTS_BIT. */
#define UART1_RTS_PORT   PORTD
/*! Data direction register of \ref UART1_RTS_BIT. */
#define UART1_RTS_DDR    DDRD
/*! \brief RTS handshake output bit.
 *
 * If undefined, RTS handshake is not supported.
 */
#define UART1_RTS_BIT    5


/*! Port output register of \ref UART1_CTS_BIT. */
#define UART1_CTS_PORT   PORTE
/*! Port input register of \ref UART1_CTS_BIT. */
#define UART1_CTS_PIN    PINE
/*! Data direction register of \ref UART1_CTS_BIT. */
#define UART1_CTS_DDR    DDRE
/*! Interrupt signal of \ref UART1_CTS_BIT. */
#define UART1_CTS_SIGNAL sig_INTERRUPT7
/*! \brief CTS handshake input bit.
 *
 * If undefined, CTS handshake is not supported.
 * Bits 0 to 3 are not supported.
 */
#define UART1_CTS_BIT    7


/*! Port output register of \ref UART1_DTR_BIT. */
#define UART1_DTR_PORT   PORTD
/*! Data direction register of \ref UART1_DTR_BIT. */
#define UART1_DTR_DDR    DDRD
/*! \brief DTR handshake output bit.
 *
 * If undefined, DTR handshake is not supported.
 */
#define UART1_DTR_BIT    7

#endif


/*@}*/

#endif